PAGE 5 OF 8 0221 IH-9234
13. Raise other side of tent and attach remaining legs.
(See Figure 19)
14. Fasten the rest of the alligator straps around EV
tubing by tugging on the valence to keep the
material taut and firmly pulling the straps. Slide
excess strap through the metal slide on the alligator
clip. (See Figure 20)
CAUTION! Yanking on straps will cause undue
wear and tear as well as wrinkling of tent top
fabric.
IF USING STAKES (H-9234)
1. Place stakes 5' out from each leg. Drive stakes into
the ground until 6" or less of the stake shows.
(See Figure 21)
2. Attach ratchet straps to the stakes loosely.
(See Figure 22)
a. Attach ratchet buckle with loop strap to stakes
by turning the 6" loop at the end of the ratchet
inside out and pulling strap through the loop.
b. Pull slipknot tight over stake.
c. Take loop strap attached to tent and pull it
through reel bars slot of ratchet.
NOTE: Keep ratchet buckle handle facing up
at all times.
3. Tighten ratchet straps by holding strap and pulling
all slack through ratchet reel. Then, with one hand,
crank ratchet handle with the other.
4. Roll excess ratchet straps
and secure into the ratchet
buckle. (See Figure 23)
ASSEMBLY CONTINUED
Figure 20
Figure 19
Figure 21
a
b
c
Figure 22
Completed Assembly
with Stakes
Figure 23
Pull to tighten.
To Next Page
Loading...