U-Line H-9234 - Securing Tent with Barrels

PAGE 6 OF 8 0221 IH-9234
ASSEMBLY CONTINUED
IF USING BARRELS (H-9246)
1. Turn the barrel upside down to connect the
mounting plate. (See Figure 24)
a. Put a large washer (1) over the nut and bolt.
b. Place the plate (2) over the washer.
c. Place another large washer (3) followed by a
smaller washer (4).
d. Place and tighten the nut (5).
e. On the opposite end of the plate, which hangs
over the barrel, place the extra bolt (6) through
the slit, securing it with a washer (7) and a nut (8).
f. Flip the barrel right side up and insert the
T-shaped bar (9) through the slit in the plate.
2. Place a pole over the T-shaped bar that has been
inserted into the plate. It will go over just the "T", not
the bolt that is attached at the back of the plate.
Put bail pin (10) through pole and T-shaped bar to
secure. (See Figure 25)
NOTE: Attach strap at bottom of barrel before
filling barrel with water. (See Figure 26)
3. To connect the strap to eye bolt in bottom of barrel,
pull looped strap through the eye bolt. Take the
other end of strap and pull it all the way through the
loop. Pull long end tight to secure strap to eye bolt.
(See Figure 27)
4. Pull strap through cover slit. (See Figure 28)
5. Connect the opposite end
of the strap to the fitting
at the top of the pole, not
around the tent frame
poles. This forms a strong
triangle. (See Figure 29)
6. Fill barrel with water.
Figure 25
Figure 28
Figure 26
Loop
Strap
Barrel
Figure 27
Figure 29
Figure 24
6
2
9
10
5
4
3
7
8
1
Bail Pin