PAGE 7 OF 8 0221 IH-9234
ASSEMBLY CONTINUED
NOTE: Keep ratchet buckle handle facing up
at all times.
7. After barrel is full, tighten ratchet straps by first
pulling all slack through ratchet reel, holding strap
with one hand and cranking ratchet handle with the
other.
8. Roll excess ratchet straps
and secure into the ratchet
buckle. (See Figure 30)
Completed Assembly
with Ballasting System
Figure 30
TAKING DOWN TENT
1. Loosen ratchet strap assemblies and remove straps
from stakes or barrels.
NOTE: If using barrels, drain them. Lift every leg
and remove pin from barrel, setting legs on
ground not back on barrel. Move the barrels
away from tent to make room for lowering tent.
2. Remove three adjacent side legs. (See Figure 31)
3. Unfasten all alligator straps except the two at each
corner (one at each side of corner). (See Figure 32)
4. Start with upwind side. Have another person remove
two corner legs from one side and carefully set tent
frame on the ground. (See Figures 33-35)
Figure 32
Figure 33
Figure 34
Figure 35
Figure 31
3
1
2
Wind
Wind
Wind
Two Person Takedown
Recommended
Wind
To Next Page
Loading...