PAGE 4 OF 30 0318 IH-7259
OPERATOR'S MENU
To enter the operator's menu, press and hold the up/
down arrows ( / ) for five seconds.
Film Type Selection Available to the Operator
• ON allows the operator to select film types.
• OFF does not allow the operator to select film types.
Roll Size Adjustment
• Adjust the diameter of the roll when using the
optional roll winder arm (H-7283).
• 20-40" diameter.
• 2" increments.
Batch Size Adjustment Available to the Operator
• ON allows the operator to adjust batch sizes.
• OFF does not allow the operator to adjust batch sizes.
LOADING MATERIAL ROLL
NOTE: User must set up and select film type
before first usage. See Film Code Settings on
page 5.
1. Load the material roll onto the material mandrel.
(See Figure 9)
• Hold the new material roll so that the open end is
facing towards the control panel.
• Slide the roll fully onto the mandrel so that the end
of the core is contacting the collar.
2. Feed the material into the system. (See Figure 10)
• Lower the clamp handle to open the edge seal
assembly.
• Thread the material under the black directional roller.
• Spread the open end of the material and wrap
around the inflation nozzle (bent metal tube) and
the material "flapper."
• Thread between the two wheels on the edge seal
assembly.
3. Close the clamp and make a few feet of inflated
cushioning material. (See Figure 11)
• While maintaining tension on the material, raise the
clamp handle to close the edge seal assembly.
NOTE: If the material is not inflating and/or
sealing after 8", re-feed the material.
See step two.
SYSTEM SETUP CONTINUED
Figure 9
Mandrel
Figure 10
Material
"Flapper"
Inflation
Nozzle
Clamp Handle
(Open)
Edge Seal
Assembly
Figu re 11
Start Key
Clamp Handle
(Closed)
To Next Page
Loading...