uAvionix AV-30-C - Changing Squawk Code; Changing Flight Identification (ID); Changing Transponder Mode

UAV-1003947-001, AV-30-C, Installation Manual 36
Rev E
Table 7 - Installation Menu Setting
Label
Description
Values
UNIT FUNCTION
Unit functionality
Set to default mode: AI* or DG
FUNCTION LOCK
Functionality Lock
If locked, pilot may not change unit function
PITCH TRIM
[AI]
Pitch trim
Trim as needed: ±20 Degrees (0*)
ROLL TRIM
[AI]
Roll trim
Trim as needed: ±5 Degrees (0*)
SLIP TRIM
[AI]
Slip trim
Trim as needed: ±5 Degrees (0*)
OAT TRIM
[AI]
OAT probe trim
Trim as needed: ±200 (Unitless) (0*)
IAS TRIM
[AI]
IAS trim
Trim as needed: ±50 KTS or MPH (0*)
ALT TRIM
[AI]
Barometric altitude trim
Trim as needed: ±500 Feet
IAS UNITS
[AI]
IAS display units
Knots* (KTS) or Miles Per Hour (MPH)
IAS VSO
[AI]
Stalling speed in landing
configuration
Set to match limits: 40 to 300 knots (50*)
IAS VS1
[AI]
Stalling speed in a specific
configuration
Set to match limits: 40 to 300 knots (60*)
IAS VFE
[AI]
Maximum flap extended speed
Set to match limits: 40 to 300 knots (100*)
IAS VNO
[AI]
Maximum structural cruising speed
Set to match limits: 40 to 300 knots (150*)
IAS VNE
[AI]
Never exceed speed
Set to match limits: 40 to 300 knots (175*)
IAS VMC
[AI]
Minimum control airspeed with the
critical engine inoperative
Set to match limits: 40 to 300 knots or disabled*
IAS VYSE
[AI]
Speed for best rate of climb OEI
(single engine)
Set to match limits: 40 to 300 knots or disabled*
BARO UNITS
[AI]
Altimeter barometric units
Inches of Mercury* (INHG), Millibars (MB)
TEMP UNITS
[AI]
OAT units
Celsius* (C) or Fahrenheit (F)
GPS NAV SRC
Serial GPS format
NONE*, AV1 9600, NMEA1 4800, NMEA1 9600,
BEACON X
SERIAL 2
Reserved
NONE*
SERIAL 3
Reserved
NONE*
AID MODE
AHRS aiding mode
NONE*, MAG1, MAG2 – MAGx only available for
units with magnetometer
VIBE MONITOR
Vibration monitor
Push to view
GYRO CAL
Calibrates aircraft gyros
Perform at installation or software update
MAG CAL
Calibrates internal magnetometer
Perform in-flight calibration after installation –
only available for units with magnetometer
DEMO MODE
Demo mode
DISABLED*, MODE 1, MODE 2
SW PART NUM
Software part number
For reference
SW VERSION
Software version
For reference
SW CHECKSUM
Software checksum
For reference
SW CERT
Software certification
For reference
[AI]
Available when Install Menu accessed through AI mode only
* Initial factory value