UAV-1003947-001, AV-30-C, Installation Manual 40
Rev E
Press the center knob and rotate to select your choice of Magnetometer
aiding and then press the center button to confirm your choice.
13.1.8 Demo Mode
Set Demo Mode to DISABLED.
13.2 System Checkout
The following procedures must be performed prior to returning the aircraft to
service.
13.2.1 Alignment
During initial startup, the ALIGN annunciator should be presented and flash.
This indicates internal sensor stabilization is occurring. During the
alignment, do not move the aircraft.
This should extinguish within 3 minutes, at which point valid attitude or
direction indication is displayed.
If power is removed from the unit while it is still aligning the unit will go to
battery mode until it has completed the alignment process.
Figure 17 - Aligning Annunciator
If the indicator is not extinguished within 3 minutes, reference the
troubleshooting section of this document for additional information.
To Next Page
Loading...
