uAvionix AV-30-C - Changing Squawk Code; Changing Flight Identification (ID); Changing Transponder Mode

UAV-1003946-001, AV-30-C Pilot’s Guide 36 Revision D
Page
7.8.2 Changing Squawk
• Press and release the center knob.
• Navigate highlighted cursor to desired digit by rotating the knob.
• Press and release the center knob to select the squawk digit to change.
• Rotate the center knob to change the highlighted squawk digit.
• Press and release the center knob to accept the changed squawk.
• Press and release the left button (DONE) to finish and save the setting.
7.8.3 Changing Flight ID
• Press and release the center knob
• When the Squawk code is displayed, push and hold the center button
again until FLIGHT ID appears
• Press and release to enter the first value
• Rotate center knob to change the Flight ID value. When desired value
appears, push the center knob to accept the value
• Push and release the right button (CLEAR) at any time to clear the
Flight ID completely
• Navigate highlighted cursor to desired character by rotating the knob
• Repeat until the entire Flight ID has been entered
• Press and release the left button (DONE) to finish and save the setting
Note: No spaces are permitted in the FLIGHT ID
7.8.4 Changing Transponder Mode
• Press and release the center knob.
• Press and release the right button to cycle through each mode selection
(STBY, ON, ALT).
• Press and release the left button (DONE) to finish and save the setting.
7.8.5 To Send IDENT
• Press and release the left button