UAV-1003946-001, AV-30-C Pilot’s Guide 47 Revision D
Page
11.4 Setting AoA Upper Limit
The objective is to set the upper AoA limit such that the first red bar
illuminates at roughly the same time as the on-set of the aircraft’s stall
warning system.
To find the upper limit, the following procedure is recommended:
• Ensure the AV-30-C is in INSTALLATION MODE (see Section 0).
• Select a safe altitude suitable for stalls, minimum 1,500 feet AGL.
• Aircraft Configuration:
o Airspeed V
FE
or less
o Flaps 20°
o Power as required
o Stable flight conditions
• Slowly reduce speed at a rate of 1 knot per second and maintain a constant
altitude.
• Monitor the displayed AoA as the aircrafts angle of attack increases.
• If the aircrafts stall-warning occurs prior to the indicator reaching the first red
bar, the upper AoA limit needs to be numerically lowered to coincide with the
aircrafts stall-warning point.
• If the aircrafts stall-warning occurs after the indicator has reached the first red
bar, the upper AoA limit needs to be numerically raised to coincide with the
aircrafts stall-warning point.
• Utilize the Setup Menu section and associated procedure in this manual to
adjust the upper limit as required.
• Repeat the above procedure as needed and to ensure consistency.
To Next Page
Loading...
