uAvionix AV-30 - Transponder Control and Testing; Displayed Transponder Fields; Transponder Mode Operations; Transponder Testing Procedure

IDENT
When identing, PALT
will display IDT
Current Page
Selector
Push to return to AI,
DG or MFD screen
SQWK
Squawk code
NIC
NIC encoding is used to indicate the
radius of containment around the
aircraft. 91.227 requires a minimum
NIC of 7.
PALT
Pressure altitude
Flashing green indicates interrogation
1. Set transponder mode to STBY
2. Option 1
a) Go to the tailBeaconX
and connect using the
tailBeacon app.
b) When app opens, go to
the bottom of page and
push “GND TEST MODE”
3. Option 2
a) Go to the AV-30 Install
Menu
b) Select BEACONX GTM
then push “ENABLE”
4. Now set the AV-30 to ALT.
5. tailBeaconX will now respond to all
calls from transponder test sets.
Testing the transponder
Field Values Displayed
N Number
N number will be displayed
correctly once the setup of the
BeaconX transponder has
been completed.
MODE
ALT – altitude
STBY – standby
ON – on
NACp
This indicates the accuracy of
the aircraft position being
transmitted. 91.227 requires a
minimum NACp of 8.
STAT
Status of transponder
Squawk Set Mode
VFR/MODE
Press to quick-set SQUAWK
to VFR.
Press and hold for
transponder mode control
followed by press and
release to change mode.
Push to enter SQUAWK mode ⚫ Rotate to
change value ⚫ Push to advance and accept
If SQUAWK is displayed,
push and hold to enter
FLIGHT ID entry mode.
Flight ID Mode
AV-30 Quick Reference Card
Transponder Control Display State
www.uavionix.com/support Support: (844) 827
-2372
FOR REFERENCE ONLY
UAV-1005760-001 Rev E
TESTING