UBC Cool KegMaster-2 - General Information about KegMaster; Technical Parameters

2
PLEASE CAREFULLY READ THIS MANUAL
This manual is intended for the user. It describes the appliance, correct
installation and operating procedures for safe use. Please read and follow all
safety rules and operating instructions before first use of this product.
1. General information about KegMaster.
The keg cooler is used to prevent beer in a keg from warming up in
temperatures from 10 - 32
0
С (50-90F)
UBC Cool reserves the right to make necessary changes and
modifications to the keg cooler.
2. Technical parameters
Outside temperature 10 - 32
0
С (50-90F)
The keg cooler is intended for use with a standard power line
115V ±10%, 60Hz, 15Amp.
Table.1
№
Parameter
Unit.
1.
Voltage
V/Hz
115/60
2.
Operating current
А
3.7
3.
The final temperature of the product (beer) in
the keg depends on the position of the
termostat handle
maximum
freezing
+1
0
С (33.8
0
F)
minimal
freezing
+8
0
С (46.4
0
F)
4.
Thermostat max. / min. freezing
0
С (
0
F)
-2/+4 (28.4 / 39.2)
5.
Net weight
kg. / ft.
64 / 141,1
6.
Max number of beer lines
pcs
1-2
7.
Dimensions without a dispensing tower
Width
Depth
Height
inches
23.6
30.98
39.17
8.
Dimensions with a dispensing tower
Width
Depth
Height
inches
23.6
30.98
57.6
9.
Compressor capacity
hp
1/5
10.
Capacity of the compressor at -10
0
С
Wt BTU/h
278
949
11.
Coolant R – 134A
kg / lb
0,200 /0,441
12.
Heat exchanger fan
Flow rate
Output
М
3
/h
Wt
180х2=360
17х2=34
13.
Evaporator fan
Flow rate
Output
M
3
/h
Wt
180
17