5. Terms of use, transportation and disposal of the keg cooler.
Description of the keg cooler and usage instructions
The keg cooler needs to be equipped with the following accessories
and parts for dispensing of beer: CO2 cylinder, CO2 regulators, air
lines, keg coupler, beer line. Beer is pushed from the keg to the
dispensing tap by CO2. The pressure is set with the regulator.
Keg cooler assembly
The keg cooler’s housing is manufactured of powder coated metal and
has a stainless steel top and inside surfaces (1). The cooler is installed
on four caster wheels with brakes (14, 15). The top of the keg cooler
has metal railings (6), dispensing tower (12) and a drip tray (13) for
spilled beer. A cool beer keg is placed into the keg cooler (3). A coupler
(4) is put into the keg. The coupler has beer lines and a CO2 line (5)
connected to it. A CO2 cylinder with manifolds (9) and a reducer (10) is
kept outside of the keg cooler (8) The CO2 line is drawn inside the keg
cooler to get connected to the coupler trough a hole in the back of the
unit.
The fan, and heat exchanger are located in the refrigeration chamber
(10). Temperature inside the keg cooler is set with a thermostat (2).
The refrigeration units can be reached for service by removing the
covers (11).
To Next Page
Loading...