NINA-W1 series - System integration manual
UBX-17005730 - R11 Software Page 22 of 55
C1 - Public
Figure 14: Screenshot after entering the filename for the sdkconfig
☞ Make sure your configuration is saved first and then enter Exit to exit the console.
Now the project is ready to build, but before building and flashing, NINA-W10 should be prepared to
accept the downloaded file. This is done by holding the BOOT button while resetting or powering on
the board.
Then, enter “make flash” to build and flash the NINA-W10 as shown below:
Figure 15: Compiling of the example application
Now, reset the NINA-W10 by clicking the RESET button.
Then, enter “make monitor” to open a serial port monitor program to the NINA-W10.
You could also enter “make flash monitor” to build and flash and then start the serial port monitor
program using only one command.
To Next Page
Loading...
