To end a call, push the “Phone Hang-up” button on the
steering wheel or the “Answer” button on the radio touch-
screen.
Mute (Or Unmute) Microphone During Call
During a call, push the “Voice Command” button
on
the steering wheel.
After the BEEP, say “mute” to mute the microphone (or
“mute off” to un-mute the microphone).
Transfer Ongoing Call Between Handset And
Vehicle
During a call, push the “Voice Command” button.
After the BEEP, say “transfer call.”
SMS Message Reader
The system can read the messages received by the mobile
phone.
To use this function, the mobile phone must support the
SMS exchange function via Bluetooth.
If this function is not supported by the phone, the corre-
sponding
button is deactivated (greyed out).
When a text message is received, the display will show a
screen where the options “Listen,” “Call” or “Ignore” can
be selected.
Press the
button to access the list of SMS messages
received by the mobile phone (the list displays a maxi-
mum of 60 messages received).
SMS Message Reader Activation/Deactivation
The SMS message automatic reading function can be
activated/deactivated by pressing the corresponding but-
ton on the display, which is shown after pressing the phone
selection button.
NOTE: On some mobile phones, to make the SMS voice
reading function available, the SMS notification option on
the phone must be enabled: this option is usually available
on the phone, in the Bluetooth connections menu for a
device registered as Uconnect. After enabling this function
on the mobile phone, it must be disconnected and recon-
nected with the system to make it effective.
7
UCONNECT PHONE 45
To Next Page
Loading...
Need help?
General
