Need help?Do you have a question about the Uctronics RM0004 and is the answer not in the manual?
General| Brand | Uctronics |
|---|---|
| Model | RM0004 |
| Category | Racks & Stands |
| Language | English |
Configure the Raspberry Pi's config.txt file to enable i2c1 and set its baudrate.
Implement a script in config.txt for safe shutdown using the power button.
Clone the library and compile a script for manual OLED display execution.
Modify rc.local to automatically run the OLED display script on boot.
Confirm the OLED display shows system information and supports safe shutdown.
Connect the top panel to the bottom panel of the rack mount enclosure.
Fix the assembled metal housing using M3*5 screws.
Attach the side brackets to the housing using M3*5 countersunk screws.
Fix the LCD display and power button using M2.5*5 round-head screws.
Secure the 2.5" SSD onto the SATA shield.
Connect the Raspberry Pi and SATA shield using the SSD adapter.
Insert the USB adapter and connect the power button/OLED cables.
Insert the SD card adapter into the Raspberry Pi's micro-SD card slot.
Push installed modules into the enclosure and tighten captive loose-off screws.
To Next Page