37
EN
0.5 liter. 0.5L water can be used for steaming food for 30 minutes.)
3. Put the airproof ring on the bowl lid, and then cover the bowl lid.
4. Turn the bowl lid until it is locked in position.
5. Put on the steamer.
6. Put the food on the steamer, and then cover the lid.
7. Plug in and press “On/Off” button.
8. Set the speed (01), the time and the temperature you need.
9. Press “Start/Stop” button, the appliance starts to working and the timer is counting down.
10. Sound “Beep” will be heard after the working time is up. All the settings are cleared and the
appliance goes back to stand-by state.
11. After use, turn the main appliance off and remove the steamer lid.
12. Take out the processed food from the steamer.
Caution:
1. Danger of scalding by hot steam and hot condensed water.
2. Never heat up the bowl when it is empty.
3. If the lid is not tted properly, the steam will escape and food inside steamer will not cook properly.
4. Never leave the measuring cup on the bowl lid when using the steamer.
5. The hot steam and hot condensed water is dangerous. Please handle it carefully.
6. Don’t touch the metal part of the bowl while it is hot. Only hold the handle of the bowl to move the bowl.
7. 30 minutes steam cooking requires 0.5 liter (500ml) of water, you need add around 250ml of water for
each additional 15 minutes.
How to use stirring attachment (Buttery):
The buttery will help you to achieve the best results while whisking cream, beating mayonnaise or egg white.
Install/remove the buttery: (L)
1. Hold the ball-shaped end of the buttery.
2. Insert the buttery on the upper part of the blade, a sound “click” will be heard. That means the
buttery is well installed on the blade. (See the above gure)
If you want to remove the buttery from the blade, just hold the ball-shaped end and pull it out with
rotations in both directions.
Use the buttery:
Please follow the steps:
1. Install the blade and the buttery on the bowl.
2. Put the food in the bowl.
3. Then cover the bowl lid.
4. Turn the bowl lid until it is locked in position. And put the measuring cup on the bowl lid.
5. Plug in and press “On/Off” button.
6. Set the time and the speed you need. Press “Start/Stop” button, the appliance starts to working and
the timer is counting down. If you skip the timer setting, the timer is counting.
7. Sound “Beep” will be heard after the working time is up. All the settings are cleared and the appliance
goes back to stand-by state.
8. After use, turn the main appliance off. Remove the bowl lid.
9. Take out the processed food from the bowl.
Caution:
1. Only switch on after the buttery has been positioned into place correctly!
2. Don’t add ingredients that might damage or block the buttery when the blade is in motion and the
buttery is tted.
To Next Page
Loading...
Need help?
General
