4
Endoscope Installation
Endoscope is a practical inspection tool necessary for inspection or maintenance work,
and is widely used in drainage pipe, air conditioning, wall circuit, home appliance
inspection, small opening observation, or automobile reparations.
To install the endoscope, first use a screwdriver to unscrew the upper screw of external
expansion port. Align the endoscope’s connector with the external expansion port and
tighten the screw above. If the endoscope has been installed correctly, the LED light on
the top of the endoscope camera will light up. After that, you can use the endoscope.
After you uninstall the endoscope, you can choose to use the screwdriver to tighten the
previously removed screw or not (the screw hole is waterproof).
Notes
• When you first use the endoscope, it may need some time to initialize it, please
follow the prompts step by step.
• Do not pull out the endoscope while using it, or an error might occur.
• The endoscope camera and cable are waterproof, can be used for inspection of
pipes, small openings, and so on.
• The connector of the endoscope is not waterproof, please do not put the
connector into water.
• Caution: Do not use for medical purposes!
• The external expansion port and the USB port cannot work simultaneously.
Endoscope Use
Open the Endoscope app, tap the icon at the top right corner, and then you can
choose the languages according to your needs. Next, find icon on the home screen
and enter the app. You can set resolution using the icon. Use shutter to take a photo
or tap the camcorder icon to start or stop recording.
Tap the white toolbar on the bottom of the screen to adjust the image. Tap to view
your recorded photos or videos. Tap to view the recorded photos/videos and the
shooting image simultaneously. You can slide the gear on the cable to adjust the LED
brightness, and short press the button on the cable to switch the camera or long press
the button to capture images.
To Next Page
Loading...