1. Open a small gap between the suit ring and the
suit by pressing down the back of the suit arm
hard.
2. Gently push down the tool between the ridge on
the suit ring and the suit.
Note the ’hook’ on the tool should point away from
the suit! See image.
3. Keep the tool pressed hard to the bottom of the
suit ring and bend the tool towards the suit arm
until it gets loose. Remember to push down on the
back of the suit arm at the same time.
If it is very hard to loosen it, try the tool in the same
groove 3-5cm to the side of where you push it
down.
IMPORTANT! Always use the WP designated tool (included in the box), when dismounting the suit ring,
otherwise damage of the Ultima suit ring, suit PU-ring or seal will occur. NEVER use metal tools like screw
drivers!
DISMOUNTING THE SUIT RING
Watch the instruction video on www.waterproof.eu
To Next Page
Loading...