Need help?Do you have a question about the Ultrasone LAPIS and is the answer not in the manual?
General| Type | Closed-back |
|---|---|
| Driver | Dynamic |
| Impedance | 32 Ohms |
| Driver Size | 40 mm |
| Frequency Response | 20 Hz - 20 kHz |
| Cable Length | 1.2 m |
| Connector | 3.5 mm |
Turn on the charging box and headset, press and hold the button for 3 seconds to enter pairing mode.
Go to your device's Bluetooth menu and select 'LAPIS' to connect.
Reboot, place back in box, or press 10s power button to unpair and clear records.
Switch between Normal, ANC, and Transparency modes by touch.
Press and hold the left/right ear for 1S to activate ANC modes from normal.
Press and hold the left/right ear for 1S to activate transparency modes from ANC.
Press and hold the left/right ear for 1S to return to normal modes from transparency.
Active Noise Cancellation reduces unwanted background noise.
Transparency mode helps you stay aware of your surroundings.
Click the left/right touch area to answer or hang up calls.
Long press the left/right touch area for 1S to reject an incoming call.
Click the left/right touch area to cancel an outgoing call.
Click touch area to answer a new call and hang up the current one.
Click the left/right touch area to play or pause music.
Double-click the left earphone touch button to skip to the next song.
Triple-click the left earphone touch button for the previous song.
Double-click the right ear touch area to control the voice assistant.
To Next Page
