Under Armour FLASH X - Regulatory Compliance Details; FCC, IC, and Laser Safety

IIICll!ase the separation between the equipmtnt and receiver.
Connect the equipment into an ouoo on a Circuit different from that to which
the receiver is connected.
Consult the dealer or an expeiiencfd radlO/TV technlei.Jn for ~P
uutlon: Change or modifications not expressly apt)!Offll by HARMAN could void
the user's authority to operate the tquipment.
For Products That Transmit RF Energy:
FCC AND K INFORMATION FOil USERS
This devtCe complies W1lh Pan 15 of the FCC rules and Industry Cilnada lkense-
e11tmpt RSS standard(s).
Operation Is subject to the following two conditions: (1 l This dev1Ct may not cause
harmful lnterfmnce; and (2) this device must accept any interference received,
including interlertflCe that may c:Ause undN!red operation.
FCC/IC Radiation Expo1ure Statffllfflt
This tquipment complies with FCC/IC RSS-102 radallOII txpOSure limits set forth
fOf an uncontrolled environment.
For WI-Fl SG device
FCCuutlon:
High power radan ilt allocated as prinaly users of the 5.25 to 5.35 GHz and
5.65 to 5.85 GHz bands. These radar stabons c:An cause inttmf!nce with and/or
damage this dtvkt.
No configorat1011 controls are provided for this wireless equipment allowing any
change III the frequency of operat1011s outside the FCC grant of authorizat1011 for US
operationaccOl'ding to Part 15.407 of the FCC rules .
KCaution:
User should also be advised that ,
(i) The device for operation in the band 5150 • 5250 MHz is only for indoor use
to reduce the potential for harmful interference to co-channel mobile satellite
systems; (ii) tilt mrumum antenna gain permitted for devi<ls in the bands 5250 •
5350 MHz aod 5470 · 5725 MHz shall comply with the e. ir.p. limit and
(iii) The maximum antenna ga,n permitted for devKes in tilt band 5725 • 5825 MHz
shall comply with the e.l.r.p. limits specified for point-to-point and non point-to-
potnt operation as app,oprwlf .
(Iv) Usm should also be advised that high - lJOW'f radars are allocattd as primary
users (1.e . priority users) of the baods 5250 • S350 MHz and 56S0 • S850 MHz and
that these radars could uuse Interference illd/« damage to LE · LAN devices .
Expo1ure of humw to RF fields (RSS-102)
The computers employ low gain mtegr.il antennas that do not emit RF field in
excess of Health Canada limits for the general population ; consult Safety Code 6,
obtainable from Health Canada ' s~ srte at hnp://www.hc - sc.gc.ca/
The radiated energy from the antennas connected to the wireless adapters
conf01ms to the IC limit of the RF exposure requirement regarding IC RSS-102,
Issue S clause 4. SAR tesls are cooducted using recommended operating positions
accepted by the FCU RSS with the device transmitting at its highest cen1fied
power level mall tested frequency band without distance attaching away from the
body. Non-compli,mce with the abovt restrictions may result in violation of FCC
RF txpOSU1' guidelines .
Ust Rtstriction Attention In France , operation is limited to Indoor use within the
band S150-5350 MHz.
For Products with Radio Receivers That Can Use an
External Antenna (USA ONLY):
CATV (Cable TV) or Antenna Grounding
If an outside antenna or cable sy\tem is coonected to this product , be cenain that
it ls grounded so as to provide some protection against voltage surges aod st.Jtic
charges . Section 810 of the National Electrical Code (NEC), ANSI/NF PA No . 70-1984 ,
provides information with respe<t to proper grounding of the mast and wpporting
structure, grounding of the lead-in wire to an antenna discharge urut, size of
grounding conductors, location of antenna discharge unit, connection to grounding
electrodes and requ11tmN1ts of the grouoding electrode .
Note to CATV System Installer:
This reminder is provided to call the CATV ( cable lV) system installer's attention
to article 820--40 of the NEC , which provides guidelines fOf proper grounding and,
in parucular . specifies that tilt cable ground shall bf c onnected to the grounding
. system of the building. as close to the point of cable entry as possible .
For CD/DVD/Blu-ray Di!C• Pl,ytn:
uution:
This product uses a lase, system . To p!Mllt dlfect exposure to the Llser beam, do
not open the cabinet enclosure °' defeat any of the safety mechan1S1T11 provided
for your protection DO NOT STARE INTD THE LASER BEAM . To ensure proper use of
this produel please read the ownen manual carefully and reta,n 1t for future ust .
Should the unit require maintenance°' repair. please conlact your local JSl service
center . Refer servKillg to qualified pmonnel only .
Cl.ASS 1 LASER PROOUCT
l<LASSE I LASER PRODUKT
LUOKAN I LASER LAITE
KLASS 1 LASER APPAAAT
CLASSE 1 PROOUIT LASER