Need help?Do you have a question about the UNEEKOR EYE XO 2 and is the answer not in the manual?
General| Compatibility | PC |
|---|---|
| Data Measured | Ball speed, club speed, launch angle, spin rate |
| Software | UNEEKOR software suite |
| Connectivity | Ethernet, USB |
| Power | AC Power |
| Operating System Compatibility | Windows 10 |
| Sensor Type | High-speed camera |
Explains grounding requirements for electrical safety.
Explains warning, caution, and never symbols used in the manual.
Lists general safety precautions for operating the machine.
Details the minimum PC specifications for the software.
Lists all the items that come with the sensor package.
Lists tools and parts required for hardware installation.
Guides on how to mount the bracket to the ceiling.
Instructions on how to insert the sensor into the mounted bracket.
Details how to connect the Ethernet and power cables to the sensor.
Verifies the connection status before software installation.
Explains how to use and place trouble mats for calibration.
Warns about PC requirements and connection status before installation.
Guides on downloading the launcher and creating an account.
Details connecting the EYE XO2 via Ethernet and verifying network interface.
Instructions on how to activate the necessary software licenses.
Lists the calibration chart and level tool needed for setup.
Specifies the exact mounting position for accurate calibration.
Follows launcher prompts for calibration and proper mat placement.
Guides on placing and aligning the calibration board.
Uses a level tool to ensure the hitting mat is perfectly flat.
Explains how to start the calibration process after setup.
Describes the screen shown after calibration without trouble mats.
Guides calibration using trouble mats and configuring zones.
Perform a test shot to verify calibration accuracy.
Analyze test shot results and finalize setup.
Finalizes installation and calibration after using trouble mats.
Identifies key areas on a club face for sticker application.
Provides specific instructions for applying stickers to drivers and irons.
Details sticker application for woods and hybrids, including fitment.
Explains sticker placement on drivers without grooves.
Explains club speed and smash factor measurements.
Defines attack angle, club path, and face angle in golf data.
Explains dynamic loft and club lie angle for golf shots.
Defines ball speed, side spin, and back spin metrics.
Explains side angle and launch angle of a golf ball.
Defines angle of descent and flight time for a golf ball.
Explains carry, run, and total distance of a golf ball.
Lists the components and data interface specifications.
Provides links to overview guides and the launcher.
To Next Page
