F. Using Holster
Three different ways to use holster:
1. Set holster parallel on the table, do not open
the tilt stand (see diagram 1).
2. Set holster in a small angle on the table, tilt
it up by the first part of tilt stand (see diagram 2)
3. Set holster in a large angle on the table, tilt it
up by all two parts of tilt stand (see diagram 3).
figure1 figure2 figure3
E. Accessories
1. A book of users manual
2. A pair of test lead
3. A pair of WRN-01B bread temperature probe
(for UT53 and UT55 ONLY)
4. A piece of holster (if selected)
17
UT52/53/54/55: 315mA, 250V fast acting fuse,
φ 5x20mm
6. Rejoin the case bottom and the case top, and
install the screw and rubber feet
Replacement of fuses is seldom required.
Burning of a fuse always results from the
improper operation.
Model UT51-55: OPERATING MANUAL
To Next Page
Loading...
