EasyManua.ls Logo

Unical HP OWER 320RK - Lifting and Handling

Unical HP OWER 320RK
88 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
CAUTION: The unit must be installed so as to allow free movement for repair and maintenance operations. The warranty
does not cover costs for platforms or other lifting equipment needed for any interventions.
CAUTION: The unit must be installed so as to allow free movement for repair and maintenance operations. The warranty
does not cover costs for platforms or other lifting equipment needed for any interventions..
All the maintenance operations and tests must be done by QUALIFIED PERSONNEL ONLY.
Before any operation on the unit, make sure that power is disconnected.
Do not use equipment to speed up the defrost process or for cleaning except for those recommended by the manufacturer
Do not perforate or burn
CAUTION: There are some moving components inside the unit. Pay the utmost attention when operating in their vicinity,
even if power is disconnected.
The heads and delivery pipe of the compressor are normally quite hot.
Be careful when working near the condensing coils.
The aluminium fins are very sharp and can cause serious injuries.
After the maintenance operations, close the panels by fixing them with screws.
5.2 TRANSPORT AND STORAGE LIMIT TEMPERATURE
Minimum storage temperature [°C]
Maximum storage temperature [°C]
5.3 LIFTING AND HANDLING
The handling must be performed by qualified personnel, properly equipped with appropriate tools to the weight and the encumbrance of the
unit, in compliance with safety regulations of accident preventing.
It is recommended:
1. check the weight on unit technical label or on table of tecnical data
2. check moving the unit there are no disconnected paths, ramps, steps, doors that could affect the movement and damage the unit;
3. make sure the unit stands while moving;
4. prima di movimentare l’unità verificare che le attrezzature siano idonee a sollevare e a preservare l’integri dell’unità; 5.
check the unit center of gravity and align it with lifting point;
6. perform lifting only by one of the listed procedures;
7. Before starting handling make sure the unit is in stable equilibrium
5.3.1 Lifting mode
Following lifting moes are allowed:
- forklift truck
- ropes/chains + sling bar
Make sure to tension the lifting ropes gradually and check their correct positioning.

Table of Contents

Related product manuals