[58] ADDITIONAL INFORMATION
www.uniden.com
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register all the handsets you have (see "De-register the handset (Handset
only)" on page 30).
2. Register the handsets by following step 2-3 in "Register the handset" on
page 15.
Find Handset
To locate the handset, press find handset on the base
when the phone is in standby mode. All registered
handsets beep for 60 seconds, and
Paging
appears on
the handset display. To cancel paging, press any key
on the handset or find handset on the base.
If the battery pack is
completely drained, the
handset will not beep
when paging.
note
ADDITIONAL
INFORMATION
TRU8865_1st.book 58 ページ ２００４年１月７日 水曜日 午後１２時１分
To Next Page
Loading...
Need help?
General
