Optional Power Brick Installation
With PC face down on a padded/protected surface, insert the (2)
14” zip ties through the holes provided in the tabs as shown.
Place power brick between the two tabs.
Bundle as much power cord as needed on top of the Power Brick –
hold in place while securing/tightening the two zip ties.
You may choose to snip off any excess Zip-Tie after tightening.
Warning: Do not cut any wiring/cables.
The mount was designed to stow the power brick and power cord for a cleaner installation.
This method is for both Desktop and Wall Mount installations. It will not work with Flat Mount installations.
4
To Next Page
Loading...
Need help?
General
