Unipower Aspiro 1U - Caution; Storage and Transportation; Disposal; Handling Electrostatic Sensitive Devices

Page 17
POWERING TECHNOLOGY
Document No. M00035-MAN rev. 3a
aspiro1u_m35-man-rev3a-0417.indd
3.2 Caution
3.2.1 Storage and Transportation
CAUTION During storage and transportation, the units must remain in their original
packages in order to avoid mechanical damage, maintain tracability, and protect the units
against electrostatic discharge.
3.2.2 Disposal
CAUTION The product should not be disposed with other wastes at the end of its working
life so as to prevent possible harm to the environment or human health from uncontrolled
waste disposal.
3.2.3 Handling Electrostatic Sensitive Devices
CAUTION An electrostatic sensitive device is an electronic component that may be
permanently damaged by the discharge of electrostatic charges encountered in routine
handling, testing and transportation.
3.2.4 Traceability
CAUTION Units are labeled with permanently attached product identication labels.
The labels are designed to be indelible throughout the life span of the equipment, unless
mistreated. Make sure that the product identication labels are present on the equipment
and are not subjected to unusual wear or mistreatment.
3.2.5 Breakers
CAUTION Breakers should always be replaced with the same type and rating in order to
avoid damage to system components.
3.2.5.1 Circuit Breaker Limitations
1. Limitations for ambient temperature up to 47°C, maximum system output current 45
Amps:
Maximum load per circuit breakers rated:1A, 4A, 5A, 7.5A, 10A, 15A, 20A and 25A is
80% of their nominal rate.
Maximum load per circuit breaker rated 30A is 60% of its nominal rate.