Page 28
POWERING TECHNOLOGY
Document No. M00035-MAN rev. 3a
aspiro1u_m35-man-rev3a-0417.indd
NOTE The interblock Connection Kit is not delivered with the system.
NOTE Symmetry cable is normally pre-connected to the system, see Figure 4-7.
4.5.7 Temperature Sensor Connection
Temperature Sensor Connection for supervising battery temperature is usually delivered pre-
installed when used. On the occasion that it is tted later it is connected using the three-pin
plug according to the same procedure as for the alarm connections.
The sensor itself should be fastened to the battery after battery installation: Unwind the
cable, remove the paper covering the adhesive for the sensor and fasten the sensor to the
battery as shown in Figure 4-13.
Figure 4-13 Temperature Sensor Connection
NOTE Temperature sensor is normally pre connected to the system, see Figure 4-7.
To Next Page
Loading...