Unipower Aspiro 1U - Breaker Replacement; Figure 7-3 Replacing an Xpge12.48 Rectifier; Figure 7-5 Top Cover Removal

Page 40
POWERING TECHNOLOGY
Document No. M00035-MAN rev. 3a
aspiro1u_m35-man-rev3a-0417.indd
1 2
Figure 7-3 Replacing an XPGe12.48 Rectier
CAUTION After rectier rebooting, check that the green LED is lit.
7.3 Breaker Replacement
WARNING Make sure the system is switched OFF.
To replace a faulty circuit breaker, follow the steps below:
1. Remove the top cover by loosening 4 screws on each side of the system and one screw
at the rear, see Figure 7-5.
Figure 7-5 Top Cover Removal