To Next PageTo Next PageWhat does Symmetry Fault mean on Unipower Aspiro 1U?
If your Unipower Power Supply shows a Symmetry Fault, it could be due to the battery being at the end of its life, a wrong symmetry cable connection, or a wrongly set Symmetry limit value. Verify the battery condition, symmetry cable connection, and the Symmetry limit value.
What should I do if Unipower Power Supply shows Battery Fuse Failure?
If your Unipower Power Supply reports a Battery Fuse Failure, it's likely due to a tripped load breaker or a blown load fuse. Verify there is no short circuit in the load or battery cabling and ensure the breaker/fuse is correctly rated. Reset the breaker; if it trips again, there is a problem with the load, battery, or the breaker itself. Replace the breaker/fuse if necessary.
What causes Distribution Fuse Failure in Unipower Power Supply?
If your Unipower Power Supply experiences a Distribution Fuse Failure, it is caused by a tripped load breaker or a blown load fuse. Verify there is no short circuit in the load cabling. Reset the breaker; if it trips again, there is a problem with the load or the breaker itself. Replace the breaker or fuse if necessary.
How to resolve Communication Failure on Unipower Power Supply?
If your Unipower Power Supply is showing a Communication Failure, it could be due to a module failure, modules not installed in the correct position, or a broken/disconnected communication wire. Check the non-communicating address. If the rectifier address does not communicate, reinstall the module and wait for 5 minutes. Verify the communication cable is properly connected and not damaged; replace it if necessary. If the board address does not communicate, check if it is installed in the system; if it is, replace the board. If there is a non-communicating module or unit, remove the non-communicating address from the controller only if you are sure you do not use them anymore. Verify if the controller is operating properly; if not, replace it.
Why does Unipower Aspiro 1U Power Supply show Load/Battery Disconnection?
If your Unipower Power Supply shows Load/Battery Disconnection, it's because the system voltage has dropped below the set limit, leading to a system shutdown. Check the battery condition, AC mains connection, input breaker, and rectifier modules.
What to do if Unipower Aspiro 1U Power Supply has Overvoltage Shutdown?
If your Unipower Power Supply experiences an overvoltage shutdown, it is likely caused by a faulty module. Try re-inserting the module and wait for 5 minutes. If the issue persists, replace the faulty module.
What to check if Unipower Aspiro 1U indicates AC High Voltage?
If your Unipower Power Supply is showing AC High Voltage, it means the AC voltage has risen above the set limit. Verify the High AC voltage limit and the AC Input voltage.
How to troubleshoot AC Low Voltage on Unipower Power Supply?
If your Unipower Power Supply is experiencing an AC Low Voltage issue, it means the AC voltage has dropped below the set limit. Verify the Low AC voltage limit setting, the AC input connection, and the AC input voltage.
What causes High Load on Unipower Aspiro 1U?
If you are experiencing a High Load issue with your Unipower Power Supply, it could be caused by a faulty module or the rectifier load current exceeding the set High load limit. Compare the load current with the installed rectifier capacity. You can add a rectifier, reduce the load, verify the High load limit setting, or replace the faulty module.
Why is my Unipower Aspiro 1U Power Supply showing High System Voltage?
If your Unipower Power Supply is experiencing high system voltage, it could be due to a module failure or the system voltage exceeding the set limit. Replace the faulty module and check the High Voltage Alarm limit setting.
General| Brand | Unipower |
|---|---|
| Model | Aspiro 1U |
| Category | Power Supply |
| Language | English |
