Unipower Bluestrak Series - Figure 7 - Mating Interface Board

Page 16
BLUESTREAK SERIES
INSTALLATION & OPERATING MANUAL
POWERING TECHNOLOGY
Document Number: BLUESTREAK-MAN Rev. 6
bluestreak-man-rev6-0719.indd
SIGNAL PIN CONNECTIONS
PIN FUNCTION PIN FUNCTION
A1
#MODULE PRESENT C1 Sense +Ve
4
A2 GA6 C2 Current Monitor
4
A3 GA3 C3 GA1
A4 Standby Return C4 5V Standby
1, 3
A5 #FANOK C5 #DCOK
A6 #SMBALERT C6 SCL
B1 Sense -Ve D1 Remote Adjust
4
B2 Control D2 Current Share
4
B3 GA2 D3 GA0
B4 Standby Return D4 12V Standby
2, 3
B5 #TEMPOK D5 #ACOK
B6 SDA D6 #ENABLE
Notes:
1. Current rating of +5V standby is 1.8A.
2. Current rating of +12V standby is 0.8A.
3. Total standby consumption limited to 9.6W.
4. Referenced to -Ve Sense.
12.3 Mating Interface Board - Figure 7 shows a mating interface board which is available for
simplifying the testing of a BLUEstreak module. As shown in the photograph, provision
is made for input and output connections as well as the control and monitoring signals and
PMBus interface.
Figure 7 - Mating Interface Board