Unipower Bluestrak Series - Introduction; Figure 1 - Bluestreak Module & Power Shelf

Page 4
BLUESTREAK SERIES
INSTALLATION & OPERATING MANUAL
POWERING TECHNOLOGY
Document Number: BLUESTREAK-MAN Rev. 6
bluestreak-man-rev6-0719.indd
OPERATING MANUAL
BLUESTREAK SERIES FRONT-ENDS & RECTIFIERS
1.0 INTRODUCTION
This Operating Manual should be read through carefully before installing and operating the
BLUEstreak Series Front-Ends and Rectiers.
BLUEstreak is a family of high density hot-swappable, modular Front-Ends and Rectiers producing
up to 2000 watts output power. There are 6 standard models with dierent output voltages and power
levels. The modules are ultra-compact with power density up to 24 watts per cubic inch. The modules
have automatic load sharing and active output ORing circuit so they can be hot-swapped while the
system is operating. Using PMBus compliant serial communications, status and control data can be
passed between a host system or power management unit and the module..
Front panel mounted LEDs indicate various status or fault conditions and +5V & 12V standby outputs
are included. Operating temperature range is -40°C to +70°C.
BLUEstreak modules can be fully integrated into an OEM host system or alternatively installed into
one of 4 dierent 1U high 19” rack-mount power shelves. These power shelves may be connected
in parallel for increased system capacity.
Figure 1 below shows a BLUEstreak module and four modules installed into one of the power shelves.
.
Figure 1 - BLUEstreak Module & Power Shelf