5 DISPLAY UNIT
There is an optional display unit that can be connected to the UP-2210 and UP-2210R meters. The
display is controlled by Unipower’s user-friendly and self-explanatory Turn&Click
®
interface. By
turning and clicking with the dial you control the menus on the display.
Figure 30
The design is in compliance with IEC 61554 for panel instruments with cut-out dimensions:
Width: 186mm ±0 +1.1mm
Height: 92 mm ±0 +0.8mm
Depth needed is 99 mm plus space for 25 pin DSUB connector at back.
Troubleshooting: In case the display would freeze or misbehave due to any kind of outer
disturbance this can easily be solved by resetting the display. To do this remove the display cable,
wait for 5 seconds and re-insert the display cable at back of the display. The status LED of the
UP2210 is also of great help to troubleshoot any problem with the display. As long as the status LED
is Green the UP2210 is operating correctly. Should the status LED be red or not light at all this
indicates a problem with the UP2210 and accordingly the display unit will not be operating as
expected.
To Next Page
Loading...
