7.1 INSTALLATION
The GPS adapter connects to the UP-2210 via the Display Port (RJ45 connector) via a special DIN-
mounted GPS adapter, or via the RS232 port. The following sections will describe the different
connection methods in detail.
7.1.1 Connecting the GPS to the Display port
The figures below shows the different GPS module and the GPS Adapter necessary for GPS
installation. Connect the GPS to the Adapter and the adapter to the UP2210 through a straight UTP
Patch cable. Check the adapter labels carefully! The GPS and the UP2210 must be connected to the
specified port on the adapter, otherwise the communication will not work.
7.1.2 Connecting the GPS to the RS-232 port
Any GPS that supplies the proper signals and NMEA messages can be connected to the RS-232 port.
The RS-232 port does not supply any power, so the GPS must be powered externally. The following
table shows the signal required for GPS communication.
To Next Page
Loading...
