Figure 50 - RTC sync information event
The last digit indicates the source of time synchronization. “0” means PQ Schedule or manually by
PQ Online. “1” means by GPS.
If there is a communication error between the GPS and the meter there are several protective
mechanisms in the software that prevent incorrect time from setting the meter. Each time, for
instance, is verified twice before setting.
When the clock is set in the meter and the deviation is greater than 1 minute, an event will be
generated (clock deviation). This event could also be connected to a visual and/or email alarm.
The Clock Sync event, that can also be seen in the event list, only informs you that PQ Schedule has
tried to synchronize the
To Next Page
Loading...
