Unipower UP2210 - Page 72

UNIPOWER
UP-2210 Hardware installation and configuration manual
72
In example above, Figure 61, the primary voltage is 11 kV and the secondary 110 V.
The meter calculates the ratio to 100.
The current transformer ratio is 400:5 and is entered as in the picture above.
Tip! You can use if you for example want to start over again.
Press next and select your reference and trig levels, see Figure 62 below and then press next and you
will get a summary of your measure configuration, see Figure 63 below.
Figure 61
Enter measurement
transformer
nominal level.
Figure 62
Advanced settings
are described in
chapter 0
Additional
constants. Can be
used for turning
current reference by
entering -1.