Unique UGP 13 - Thermostat and Temperature Control

UNIQUE UGP 13
7
depending on distance of the fridge to propane tank. Continue pushing the
igniter button while holding in the gas button until the needle in the flame indicator
D moves into the green area (to the right).
4. When the needle starts to move into the green area, this means flame is now lit. Stop
sparking and continue to hold gas button E down for an additional 10 seconds.
Release gas button; fridge should now stay lit and needle remains in the green area.
5. Setting the thermostat to "4" will allow the fridge to get to optimum cooling
temperature. It may be necessary to adjust the temperature control on the thermostat
knob to suit your needs after 8 hours of operation.
6. The quantity of food in the refrigerator, the frequency with which the refrigerator
doors are opened and the room temperature will all affect refrigerator temperatures.
“Shut Down” Procedure
1. Turn knob C to Gas “Off” position.
Note: If using CO-Monitor, the monitor must be hooked up and be reset with the
battery installed for the flame to stay on – Refer to Chapter 6.
Thermostat
The refrigerator cooling temperature is controlled by a thermostat that can be adjusted by
turning knob B to different settings to maintain the desired refrigerator temperature.
Knob E also incorporates a safety device which automatically shuts off the supply of gas
if the flame goes out and the piezo electric igniter discharges sparks onto the burner when
the button is pushed.
Figure 5