UNIQUE UGP 13
11
Maintenance & Service
The user should be aware of service that must be done on a regular schedule to keep the
refrigerator operating properly. Installation must be by a licensed gas fitter in accordance
with local codes or must comply with Propane Installation Code CAN/CGA-B149.2
(latest edition).
REFRIGERATOR REMOVAL
Before working on the refrigerator, shut off the gas supply. Disconnect the gas supply line
at the rear of the refrigerator. Always use a backup wrench when loosening and tightening
this connection. Cap the gas supply line and remove the refrigerator. Replacement is the
reverse of removal. Check all connections for gas leaks.
Refer to Chapter 2, INSTALLATION
PERIODIC MAINTENANCE
Before working on refrigerator, shut off the gas supply. Disconnect the gas line at the rear
of the refrigerator. Always use a backup wrench when loosening and tightening this
connection. Cap the gas supply line and remove refrigerator. Replacement is the reverse
of removal. Check all connections for gas leaks. Refer to Chapter 2, Installation.
To keep your refrigerator operating effectively and safely, periodic inspection and
cleaning of several components is recommended once or twice a year, sometimes more
often depending on environment.
It's important to keep the area at the back of the refrigerator clean. Clean the coils on
the back of the refrigerator. Use a soft bristled brush to dust off the
coils.
Note:
The following maintenance is required at least once or
twice a year at least, more often based upon usage/environment.
Check all connectors in the complete refrigerator LP gas system for gas leaks.
The LP gas supply must be turned on. Apply a non corrosive bubble solution to
all LP connections. The appearance of bubbles indicates a leak and should be
repaired immediately by a qualified serviceman.
Chapter
4
To Next Page
Loading...
