UNIQUE UGP 13
30
Find the top hinge, move the hinge pin from the right side of the top hinge to the left.
Place the top hinge pin into the top of the freezer door and align the hinge with the 4
holes at the top of the cabinet.
Begin to tighten all 4 bolts, leaving them a bit loose so you can align the freezer and fridge
door before tightening.
Check that the freezer and fridge doors are aligned with the left side of the cabinet and
gaskets all fit. Also look directly at the front of the fridge and ensure the gap between the
top of the fridge door and bottom of the freezer door is the same from left to right.
Once you have everything aligned tighten the 4 top bolts, then proceed to tighten the
middle hinge screws.
Replace the top hinge cover, one screw, and replace the caps over the two middle hinge
screws.
Should the gasket not adhere to the casing of the appliance perfectly, it might have to be
heated (by means of hot water, for example) and lightly stretched to the required height.
op Hinge Pin
To Next Page
Loading...
