13
OPERATION continued
DEFROSTING
Before cleaning or repositioning the fridge, you must DISCONNECT
the appliance from the electrical power supply.
DEFROSTING THE UNIT The fridge compartment will become pro-
gressively covered with frost. This should be removed periodically
with a plastic scraper. However, when the ice becomes very thick on
the interior walls, complete defrosting should be carried out. Per-
form this operation when the appliance is empty and disconnected
from the power supply.
NEVER USE SHARP METAL TOOLS TO SCRAPE OR CHIP OFF
FROST FROM THE INTERIOR COMPARTMENT AS THIS COULD
DAMAGE THE APPLIANCE BEYOND REPAIR. DO NOT USE HEAT
SOURCES SUCH AS ELECTRIC OR GAS HEATERS TO COMPLETE
THE DEFROST PROCESS.
To perform a complete defrosting:
1. Disconnect the appliance from the electrical supply.
2. Remove any stored food and store in coolers, or wrap in several
layers of newspaper and store in a cool place.
3. Leave the doors open.
4. Remove the plug from the defrost water drain located in the bot-
tom interior of the cabinet.
5. To accelerate the defrosting process, place a bowl of hot (not
boiling) water inside the fridge and/or freezer compartments and
close the door.
6. When defrosting is complete, wash and dry the interior
thoroughly.
7. Reconnect the appliance to the electrical supply and leave running
(while empty) for at least 2 hours allowing the interior to cool suf-
ficiently.
8. Reload the fridge and freezer with the previously removed food.
ATTENTION: Partial thawing of frozen food during defrosting may
shorten its safe storage life-span.
To Next Page
Loading...
Need help?
General
