Accessories
Technical data
Electric circuit diagram
Inflating:
Always check the object
recommended pressure before
inflating it.
Inflating Toys and Balls
Maintenance, cleaning,
repairs and storage
Disposal instructions
1 Valve nozzle
2 12 V DC adaptor
3 Pressure gauge
4 Adaptors for various inflatables
• Schutzklasse: III
• Schutzart: IPXO
• Power source: DC 12 V
• Air hose length: ca. 45 cm
• Current consumption: max. 10 Ampere
• Weight: ca. 0.52 kg
• Max. air pressure: 10 bar / 150 psi
• Dimensions: w 13 x h 7.5 x d 12 cm
• Running time: max. 10 min
• Break: approx. 10 min
• Air inlet and discharge temperatures: Inlet: 0°C - 25°C
Discharge: 0°C - 70°C.
• Air inlet and discharge pressures: Inlet: Atmospheric pressure
Discharge: 10 Bar (1 MPa)
• Maximum pressure ratio: 10
• Maximum rotational shaft speed: 5000 rpm
1) Position the vehicle in such a way that the valve of the tyre to be inflated is at the bottom.
2) Now please connect the rubber tube having the snap valve to the tyre valve and then
press the valve lock down so that it firmly locks onto the tyre valve.
3) Please note that if a tyre is completely void of air, the vehicle should be raised using a
jack, so that no extra pressure will be exerted on the empty tyre.
4) Now put the plug into the cigarette lighter, so that the compressor is connected to the
power supply. Now the inflating process can commence. But do observe the inflation
pressure continuously in order to avoid excess pressure.
5) Please note that, the higher the pressure in the item being
inflated, the lower the air flow, because counter-pressure is generated in the item being
inflated. In addition, make sure that the specified pressure is not exceeded.
1) Please use the adapters provided, whenever you want to inflate balls, air mattresses or
any other inflatable items. Be extremely careful whenever inflating anything and note
the maximum pressure specified for it.
2) Moreover, take into consideration the fact that smaller items can be fully inflated
very quickly. Thus always observe them while pumping. If you adhere to the aforesaid
instructions, the compressor will serve you reliably for a long time to come.
Only clean when disconnected from the electricity supply.
• This electric appliance does not require special maintenance.
• Clean the device using only a slightly moist cloth. Do not use aggressive detergents.
• Store the compressor in dry and dust-free environment.
• The compressor is equipped with permanently lubricated, maintenance-free motor.
Never try to lubricate the compressor
• Repairs may only be carried out by qualified experts.
At the end of its useful life, do not dispose of this product in the domestic
refuse but at a point set up for the return of used electrical devices.
12V+
12V-
On/off switch
Motor
3
1
2
4
10924_Bed_A5_140912.indd 5 15.09.14 14:40
To Next Page
Loading...
Need help?
General
