1 0
M AB a s i c 2 0 0 , 4 0 0 , 4 5 0 , 8 5 0
ENGLISH
D a n g e r o f e l e c t r i c s h o c k
D ANGER
El e c t r i c s h o c k h a z a r d !
C o n t a c t w i t h l i v e w i r e s o r c o m p o n e n t s
c a n l e a d t o s e r i o u s i n j u r y o r e v e n
d e a t h !
Observe the following safety precautions
to avoid any danger from electric current:
► Do not open the housing of the
machine. Risk of electric shock if live
terminals are touched.
► Never immerse the machine or the
plug into water or other liquids.
► Only use extension cables or cable
drums with a cable cross-section of 1.5
mm².
► Only use extension cables that are
approved for the place of work.
► Check the condition of the extension
cable regularly and replace if
damaged.
► Avoid direct body contact with
grounded parts (e.g., tubes, radiators,
steel girders) to reduce the risk of
electric shock in the event of a defect.
R i s k o f i n j u r y
W AR NING
Im p r o p e r h a n d l i n g o f t h e m a c h i n e
i n c r e a s e s t h e r i s k o f i n j u r y !
Observe the following safety precautions
to avoid injuring yourself and/or others:
► Operate the machine only with the
protective equipment stipulated in
these operating instructions (see
Personal protective equipment
section).
► D o n o t wear protective gloves when
the machine is running. A glove can
be caught by the drilling machine and
torn off the hand. Risk of losing one or
more ngers.
► Remove loose jewellery before
beginning work. Wear a hair net if you
have long hair.
► Always switch off the machine
before changing tools, performing
maintenance or cleaning. Wait until
the machine has come to a complete
standstill.
► Always remove the plug from the
mains socket before changing tools,
cleaning or performing maintenance
work in order to avoid unintentional
starting of the machine.
► Do not put your hand into the machine
while it is in operation. Remove
swarf only when the machine is at a
standstill. Wear protective gloves when
removing swarf.
► When working on scaffolding, the
operator must be secured with a safety
belt as the machine can oscillate
dangerously in the event of interruption
to the power supply.
Sa f e t y
To Next Page
Loading...
General