How to Re
To ensure the unit working properly, please keep all connectors away
from the contaminants such as dust, grease, mud, and water.
Negligence may cause the unit to lose communication, short circuit, or
overheated. If the connector is damaged, please ensure the connector
is fully repaired before using the unit to avoid short circuit.
WARNING!
There is a risk of fire and burns if the battery is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts,
or dispose the battery pack in fire or water.
DO NOT attempt to open or service the battery.
Dispose used batteries according to local recycling guidelines in your area.
CAUTION!
Copyright 2022 unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
http://www.ute.com/
The detachable cover
How to Remove the Detachable Cover
Note: Please remove the detachable cover
while charging EA520 with boot case on.
1. Grab the two top edges of the detachable
cover and bent inward then lift to remove.
Insert the detachable cover into the cradle.
Make sure the arrows of the cover matches with
the cradle (Please refer to the picture below).
How to Insert the Detachable Cover
To Previous Page
Loading...
Need help?
General
