8
© 2021 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
1.4.2 Install the Battery Cover
Insert the battery cover in the direction as shown in the picture below:
1.There are three hooks on the battery cover. Align the hooks with the
recesses on the battery compartment.
2. Insert the battery cover up to 45 degrees (45°) angle, from top to bottom.
3. Align the battery cover with the recesses of the battery compartment and press the
battery cover down to secure in place. Make sure there is no gap between the
device and the battery cover.
4. Lock the battery cover by turning the latch to the right . Make sure the battery
cover is securely closed, or you may not be able to turn on the terminal.
To Next Page
Loading...
Need help?
General
