The left and right footswitch LEDs are lit when Comp 1 and/or Comp 2 is
active. The LEDs change colors to indicate compressor activity.
• Green – The compressor is not responding to the signal
• Yellow – The compressor is moderately responding to the signal
• Red – The compressor is heavily responding to the signal
Notes
• The compressor LED colors do not always indicate the presence of a signal.
For example, with a slow release time on the OPTO LA-2A, the indicator
LED may illuminate red and yellow well after the signal ends, because the
LED is indicating the compressor activity (the compressor release time) and
not the current compression amount.
• To see compressor activity on the footswitch LEDs, be sure to update to the
latest firmware with UA Connect.
Left Footswitch
Press to toggle Comp 1 on/off.
Right Footswitch
Press to toggle Comp 2 on/off.
Max Footswitch Modes
With the UAFX Control mobile app, you can change how signals are routed
within Max. Serial, Parallel, and Exclusive modes are available. The table
below summarizes how signals are routed and controlled in each of the three
available modes.
To Next Page
Loading...
