31
URC-300
The Expander converts radio signals to standard
infrared commands and sends them out via a
built-in front blaster to components in the same
cabinet space.
The Customizer sends
radio signal to the
Expander, which is a
radio receiver.
Self-adhesive “flashers” (included in the
Expander kit) affix to the front panels of your
components. The flashers relay infrared com-
mands to components out-of-sight of the
MRF-100 front blaster. The flashers plug into
the MRF-100 rear flasher line output jacks.
Each flasher has a 10’ cable to easily reach
components on nearby shelves.
To Next Page
Loading...
