Universal Robots ur3 - Page 171

C283A46 The tool moved too
fast towards a
safety plane
a) Ensure the mounted
payload, TCP and CoG
matches your configuration.
b) Slow down movements
c) Check safety setting
d) Contact your local
Universal Robots service
provider for assistance.
C283A47 Joint position limit
exceeded
a) Ensure the mounted
payload, TCP and CoG
matches your configuration.
b) Slow down movements
c) Check safety setting
d) Contact your local
Universal Robots service
provider for assistance.
C283A48 Tool position limit
exceeded
a) Ensure the mounted
payload, TCP and CoG
matches your configuration.
b) Slow down movements
c) Check safety setting
d) Contact your local
Universal Robots service
provider for assistance.
C283A49 Tool orientation limit
exceeded
a) Ensure the mounted
payload, TCP and CoG
matches your configuration.
b) Slow down movements
c) Check safety setting
d) Contact your local
Universal Robots service
provider for assistance.
C283A50 Elbow position limit
exceeded
a) Ensure the mounted
payload, TCP and CoG
matches your configuration.
b) Slow down movements
c) Check safety setting
d) Contact your local
Universal Robots service
provider for assistance.
Service Manual 165 UR3
7.Troubleshooting
Copyright © 2009–2021 by UniversalRobotsA/S. All rights reserved.