Universal 79105 - Comments or Questions?; Before You Begin

4
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following: Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at customerservice@universalgymequipment.com.
Mailing address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
5
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following: Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at customerservice@universalgymequipment.com.
Mailing address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
Comments or Questions?
Dear customer,
Congratulations on your purchase of the Universal
®
Gym Equipment PowerPak
®
LP700.
We’re sure that you will be completely satised with the product and we invite your comments so that we can
hear about your success.
Please write or call at the address or phone numbers listed below with any comments or questions you may
have.
Service and Parts - Toll free number: 1-800-472-9856 Monday through Friday-8:00 am to 5:00 PM CST
Fax: 1-662-495-5038
Website: www.universalgymequipment.com
Universal
®
Gym Equipment
A Division of FFA Corp.
Customer Service Department
100 Tubb Ave.
West Point, MS 39773
Ordering Missing or Defective Parts
When ordering parts, always provide the following information:
1. NAME, MAILING ADDRESS AND TELEPHONE NUMBER
2. DATE OF PURCHASE
3. WHERE PRODUCT WAS PURCHASED (NAME OF RETAIL STORE, CITY)
4. MODEL NUMBER (79105)
5. PART ORDER NUMBER AND DESCRIPTION
All details depicted in this owner’s manual, and of the product itself, are subject to change without notice.
Before you begin
E-mail: customerservice@universalgymequipment.com
FIND YOUR TOOLS: You need two adjustable crescent wrenchs, one set of allen wrenches and one rubber
mallet. These tools are NOT included in the carton.
LOCATE YOUR WORK OUT AREA: For your safety and convenience, you must assemble the unit exactly
where it is to be used, so that you will not have to move it once the assembly is complete. Allow ample space
for the unit and space for the spotter to stand. The area must have adequate lighting and ventilation. If the
area is within living quarters, protect the carpet or oor with a large mat prior to assembly.
GET A HELPER: It is recommended that two adults assemble the product. All persons involved in the as-
sembly should be in good health and exercise great caution while manipulating heavy metal objects. Keep
children away during assembly.
IDENTIFY YOUR HARDWARE: To identify a piece of hardware by physical size, use the rule provided on
page 5.
TIGHTEN ALL BOLTS BY HAND FIRST: Do not tighten any bolts until the entire unit is assembled. Initially,
all bolts should only be hand-tightened. Once all parts are in place, begin tightening the bolts at the top of the
unit rst, and work your way down to the oor.
INSTALLING FOAM ROLLS: Liquid soap applied to inside of foam pads and outside of tubes will help foam
pads slide on easier. When soap dries, the foam pads will stay in place.
1.
2.
3.
4.
5.
6.