18
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following: Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at customerservice@universalgymequipment.com.
Mailing address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
FIGURE 7
Step 64.
Step 65.
Step 66.
Step 67.
Step 68.
Step 69.
Step 70.
Step 71.
Thread LONG POP PIN (79A) into PRESS ARM (22).
Push 2” ROUND END PLUGS (72) into ends of PRESS ARM (22).
Insert ROLLER HANDLE BARS (19) into PRESS ARM (22) and fasten with 1/2” NYLON NUT (103), 1/2” WASHER
(99) and 1/2” CAP FOR NUT (73).
Attach one BEARING HOUSING (41) to PRESS TOP FRAME (6) with 1/2” x 1-3/4” HEX HEAD BOLTS (87), 1/2”
WASHERS (99) and 1/2” NYLON NUTS (103). See DETAIL.
With PINS to rear insert axle of PRESS SUPPORT (13) into mounted BEARING HOUSING (41). Slide other BEAR-
ING HOUSING onto axle and attach to PRESS TOP FRAME (6) with 1/2” x 1-3/4” HEX HEAD BOLTS (87), 1/2”
WASHERS (99) and 1/2” NYLON NUTS (103).
Using an allen wrench, tighten SET SCREWS in both BEARING HOUSINGS (41).
Attach PRESS ARM (22) to PRESS SUPPORT (13) with 1” PRESS ARM AXLE (34) and 1” SPACERS (98).
Pull out on LONG POP PIN (79A), swing PRESS ARM (22) to desired position and release POP PIN to lock in
place.
IMPORTANT: The BEARING HOUSINGS (41) have SET SCREWS on one side. The BEARING
HOUSINGS must be mounted with the SET SCREWS to the outside as shown in DETAIL.
To Next Page
Loading...
