20
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following: Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at customerservice@universalgymequipment.com. Mailing
address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
FIGURE 8
Step 58.
Step 59.
Step 60.
Step 61.
Step 62.
Step 63.
NOTE: The AB CABLE (49) is the longer cable with a hook on each end.
A1
Insert AB CABLE (49) through slot in LEG EXTENSION (12). With AB CABLE in groove on bottom of PULLEY (61),
attach PULLEY to LEG EXTENSION with 3/8” x 2-1/2” HEX HEAD BOLT (86), 3/8” WASHERS (97) and 3/8” NYLON
NUT (102).
A2
Insert AB CABLE (49) into front of BASE FRAME (1), push until you can pull it up through slot in BASE FRAME. With
AB CABLE in groove on bottom of PULLEY (61), attach PULLEY to BASE FRAME with 3/8” x 3” HEX HEAD BOLT
(85), 3/8” WASHERS (97), 3/8” BUSHINGS (70) and 3/8” NYLON NUT (102).
A3
With AB CABLE (49) in groove on bottom of PULLEY (61), attach PULLEY to rear hole of slot in BASE FRAME with
3/8” x 3” HEX HEAD BOLT (85), 3/8” WASHERS (97), 3/8” BUSHINGS (70) and 3/8” NYLON NUT (102).
A4
Place AB CABLE (49) in groove of PULLEY (61) and attach to SINGLE PULLEY BRACKET (24) with 3/8” x 1-3/4” HEX
HEAD BOLT (87) and 3/8” NYLON NUT (102).
A5
With AB CABLE (49) in groove on bottom of PULLEY (61), attach PULLEY to front hole of slot in BASE FRAME (1)
with 3/8” x 3” HEX HEAD BOLT (85), 3/8” WASHERS (97), 3/8” BUSHINGS (70) and 3/8” NYLON NUT (102).
A6
Insert AB CABLE (49) through slot in FRONT SUPPORT (2). With AB CABLE in groove on top of PULLEY (61) attach
PULLEY to FRONT SUPPORT (2) with 3/8” x 3” HEX HEAD BOLT (85), 3/8” WASHERS (97), 3/8” BUSHINGS (70) and
3/8” NYLON NUT (102).
To Next Page
Loading...