24
Please contact Universal
®
Gym Equipment/FFA Corp. for missing or defective parts at one of the following: Phone 1-800-
472-9856 or Fax 1-662-495-5038 or E-mail at customerservice@universalgymequipment.com. Mailing
address: Universal
®
Gym Equipment/FFA Corp. - 100 Tubb Ave. West Point, MS 39773.
Website www.universalgymequipment.com
FIGURE 10
Step 71.
Step 72.
Step 73.
Step 74.
Step 75.
Step 76.
Step 77.
Step 78.
Push BINDING OF WEIGHT SHROUD (46) completely onto edges of WEIGHT SHROUDS (35).
Attach WEIGHT SHROUDS (35) to WEIGHT TOP FRAME (5) and WEIGHT BASE (6) with 5/16” x 1/2” HEX HEAD
BOLTS (91) and 5/16” WASHERS (98).
NOTE: The following accessories can be used at different locations on the unit. The locations shown are the most
common. See your exercise chart for further information.
Attach the LAT BAR (27) to the hook on the TOP CABLE (47).
Attach the AB STRAP (30) to the hook on the upper end of the AB CABLE (49).
Attach either the ANKLE STRAP (32) or CURL BAR (29) to the hook at the lower end of the AB CABLE (49) with SNAP
HOOK (40) and LINK CHAIN (36).
Attach HANDLES (31) to hook at each end of PEC DEC CABLE (50) with SNAP HOOK (40) and LINK CHAIN (36).
Attach HANDLE STRAP (106) to each PEC DEC ARM (14 LEFT & 15 RIGHT) with SNAP HOOK (40).
NOTE: Over time the cables will need to be adjusted to remove excess slack. This can be done by first adjusting
location of PULLEY (61) in FLOATING PULLEY BLOCK (19). Then if only a slight amount of adjustment is needed
thread the cable adjustment bolt into the SELECTION ROD (28) until the slack has been removed and then tighten
locking nut against SELECTION ROD.
To Next Page
Loading...