Universal UN50 - Page 12

11
STRAIGHT
STITCHING
For
straight sewing
on
fine fabric
or
very
soft material,
you
may
want
to use the
straight stitch
presser foot
and
the straight
stitch
needle
plate which
are included
in your
accessory box.
Both have
narrow needle
slots.
Changing
the
Foot and
Plate.
To change presser
foot,loosen
thumb
screw and
remove zigzag
foot.
Replace with
hinged narrow
foot
and
tighten screw
securely.
To change
needle
plate,remove
screws
and slide
the bobbin
case
cover and
replace
the
zigzag
needle plate
with
that
for
straight
sewing, while
raising
the needle
bar
and
the
presser
foot
to
their
highest
points.
1. Set
the blind
stitch
lever
Dto
“M” position.
2. Set
the Z-B
dial
©
to
“0” position.
3.
Select
desired
stitch
length
on dial
®.
4.
Push
the button
®
and reverse
stitching
can be performed.
ZIGZAG
SEWING
Use zigzag
presser
foot and
needle
plate.
Move
the blind
stitch
lever
cDto
“M”
position.
and
select
desired
zigzag
width
on
dial
Fig.
21
Select desired
stitch
length on
dial
©.
NOTE: 1.
When you sew
thin
fabric, apply
a thin
sheet of paper
to the
reverse side
of
the
fabric.
Then
the
finished
work will not
pucker.
2. In zigzag
sewing,
loosen the
upper
tension slightly,
and
see
that the
lower thread
does
not appear
on
the surface
of the cloth.
1.
2.
3.